Office Standard 2010 Sale HP Network ScanJet 5 Con

This segment is for commercial purchasers. D.I.Y. people can needless to say also apply much less, the same,Office Ultimate 2007 Key hpcalc.org - HP48 Software Archive, far more,Office Standard 2010 Sale, or variants. But individuals purchasing a conversion value a description of what is usually furnished. I also goal to provide specifically what the buyer needs or needs, not a prepackaged answer, so will not be afraid to request for that which you want. Description subject matter to change without recognize (usually bug fixes & enhancements etc).
Top Of Page
Here is a final update (I hope) regarding the malfunctioning power supply. A short recap:
My scanjet resets during scanning. After some searching I found out that the -12 v supply collapses during scanning causing a reset of the mother board via the orange power_good signal. Connecting power_good to a constant +5V signal reduced the problem to the display. My first assumption was that the capacitors involved in the -12v circuit were bad. Replacing them however did not solve the problem.
A closer look at the -12 v supply reveals that the voltage is stabilised using a KA 78R12 voltage regulator. This IC has a voltage disable pin (pin 4) which disables the output voltage. Pin4 is connected using an opto- couple to another circuit. After connecting pin 4 with a stable voltage the reset problem disappeared. Bingo! Conclusion the -12v supply was not the cause of the problem but was merely resetting as a consequence of another problem.
Following the opto coupler I found out that it was connected to pin 11 of KA3501. Pin 11 is the power good output signal of the +12 +5 v regulator.
This signal triggered the reset of both the -12 v circuit as the mainboard.
Measuring VCC at pin 7, I measured around 18 V. Then I saw a small trimmer (potmeter as we say in Holland) close to the KA 3501. Turning this trimmer clockwise I was able to increase the VCC to 20 V. After that the problem was over.
So my recommendation with similar powersupply issues is to measure the voltage at pin 7 of the KA 3501. If it is below 20 v. Try increasing it using the trimmer and check whether symptoms disappear.

[size=9pt]The English author, Richard Savage, was once living inLondon in great poverty. In order to earn a little money he hadwritten the story of his life, but not many copies of the bookhad been sold in the shops, and Savage was living from hand tomouth. As a result of his lack of food he became very ill, but after a time, owing to the skill of the doctor who had lookedafter him, he got well again.vacuum extruder[/size][size=9pt]　　[/size][size=9pt]After a week or two the doctorsent a bill to Savage for his visits, but poor Savage hadn't anymoney and couldn't pay it. The doctor waited for another month and sent the bill again. But still no money came. Afterseveral weeks he sent it to him again asking for his money. Inthe end he came to Savage's house and asked him for payment, saying to Savage, “You know you owe your life to me and Iexpected some gratitude from you.”clay brick machine[/size][size=9pt]　　[/size][size=9pt]“I agree,” said Savage, “that I owe my life to you, and toprove to you that I am not ungrateful for your work I will givemy life to you.”[/size][size=9pt]　　[/size][size=9pt]With these words he handed to him two volumes entitled,The life of Richard Savage.[/size]