When using the ignition key

[chqingcaieg]

How to use the ignition switch?
Most modern car ignition switch is a composite type, composed of a variety of functions. General ignition switch has 4 functions: First,Audi Clutch-Audi A4 Clutch Disc, lock the steering wheel; second turn off the ignition device; third start the engine; Fourth normal operation.
Car vehicle ignition key is allocated, and generally have two. And some car keys on the key number embedded pieces of metal, keys and vehicles in use before, should be removed with a number of the metal, and properly preserved. In accordance with the number of metal can be prepared to this car repair center to a new key (new key for the preparation, the service center will have a rigorous review procedure.)
When using the ignition key, the key should be plugged into the appropriate location as required, and then rotate to the four functions of a position in any location. Remove the key, you should first press and hold the key and release the switch lever, then rotate the ignition key to the (LOCK) locking position, you can remove the key.
General Automotive are the key reminder, if you leave the keys in the ignition switch, the driver opened the door, the alarm signal will flash or beep to alert the driver.
When using the ignition switch should note the following:
(1) the car is moving during the key or not unplug the ignition switch to lock the keys (LocK) position, as this would lock the steering wheel and lose steering control. Therefore, the driving need to disconnect the ignition, just turn the key off (OFF) location.
(2) The driver should take good care of the ignition key switch to prevent theft.
(3) Feng Zhou Fang stalled vehicles, should turn off the ignition key switch position to prevent the vehicle for a long time in a discharged state, causing accidents.
(4) the direction of using an ignition key switch has been locked, turn the steering wheel can not be forced to avoid the bad steering wheel and steering torque.
(5) Wo associated with the ignition switch lock device can not start the engine, so as to avoid the grass can not be transferred after the vehicle started moving downtown and gas; the second accident
(6) ~ α for the ancillary equipment stalls, the key to this position, the power supply board on a variety of ancillary equipment to be connected, such as electric horn power, the key to this position, to ring the bell.
(7) ON is connected to file, the key to the stalls, car power supply are all connected, all devices can be used, the engine power was turned on.
(8) When to start ART file, the key to this position, that is, open the starter switch, starter motor drive running start.