How to Replace a Dell Laptop Keyboard | sunny201107

How to Replace a Dell Laptop Keyboard Laptop keys are fragile and flimsy and if you use the laptop keys a lot, chances are, at least one will pop-off. If this happens, you can probably end up replacing it. Even if you have warranty coverage, Dell Computers will insist that you change the keyboard and will not pay a technician to replace the <a href="http://www.boseling.com/"><strong>Dre Beats Headphones</strong></a> laptop keyboard for you. Sometimes it’s cheaper to find a keyboard for your model laptop elsewhere than going through the manufacture. If you find yourself in this situation, you can use these steps to replace the keyboard. Removing the Damaged Keyboard * 1 Ensure the laptop is fully powered off, unplugged from the wall, and the battery taken out. * 2 Turn the laptop over. On some models icons indicating which screws are attached to the keyboard are displayed. If not, you may have to “eyeball” it if you can’t find a breakdown for your model online. * 3 Remove those screws with a T-8 or Phillips screwdriver. * 4 Turn the laptop back over and open it up. Check and see if the keyboard is tucked under any plastic pieces. If so, find if those plastic pieces are screwed into anything, and unfasten them as well. If not, it probably uses clamps that can easily be removed. * 5 Remove <a href="http://www.boseling.com/"><strong>bose headphones</strong></a> the plastic pieces carefully with a toothpick or plastic pick if there is any in the way. * 6 Unscrew any screws at the top (if necessary) and remove the Dell Laptop Keyboard itself from top to bottom. You’ll notice that the Dell Inspiron 1440 Keyboard is connected <a href="http://www.boseling.com/"><strong>Monster Beats Headphones</strong></a> with a thin, but wide, data cable to the system board at the bottom. * 7 Take that same pick and lift the plastic connectors that hold in this data cable in place. * 8 Carefully remove the data cable. Now the whole keyboard should be free. Replacing the keyboard. * 1 Take the new Laptop keyboard out of the plastic, and slip the data cable back in between the plastic connectors on the system board. Make sure it’s all the way in. * 2 Use the pick to push the plastic connectors back into place, and make sure it’s holding the data cable in. * 3 Slip the keyboard itself into place, from bottom to top. Make sure the screw holes or clamps line up at the top. * 4 Refasten the keyboard in place at the top. * 5 If you had to <a href="http://cndfsk.com/blog/blog.php?do=showone&uid=1701&type=blog&itemid=3279 47"><strong>Tips and techniques for an easy replacement of your defective Dell ...</strong></a> remove any plastic pieces, carefully snap them back in and replace any screws you had to remove. * 6 Turn the laptop over and replace all of the laptop keyboard screws. * 7 Finally, put the battery back in and power on the laptop. If all has gone well, the keyboard should be functioning like brand new. Tips &amp; Warnings * To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or periodically touching the connector on the back of the laptop (or any unpainted metal).